Esim Proxy

Service guide: install eSIM on iPhones that already have eSIM hardware mod / Fake ICCID / international units blocked from adding eSIM. This is not a carrier eSIM plan by itself — you still need a valid eSIM QR (from the shop or the carrier).

Step 1 — Install the configuration profile

• Connect to Wi‑Fi.

• On the iPhone, open Safari and TAP HERE FOR DOWNLOAD PROFILE . When prompted, choose Allow.

Then go to Settings → Profile Downloaded (or Settings → General → VPN & Device Management) → select the profile «Turbosimproxy eSIM» / «esim proxy» → Install → enter the device passcode → Done.

Trust the certificate — without this, adding eSIM will fail:

Settings → General → About → scroll to Certificate Trust Settings → enable the switch for the certificate (usually shown as mitmproxy or eSIM_INSTALL) → Continue.

Step 2 — Set the Wi‑Fi proxy

Settings → Wi‑Fi → tap the (i) next to the connected network → Configure Proxy → Manual. Enter exactly:

• Server: 62.169.24.229

• Port: 6666

• Authentication: On

• Username: khach

• Password: esim@2026

Tap Save.

Step 3 — Add the eSIM

• Open Camera, scan the eSIM QR (plan QR from the shop, or the carrier QR) → tap Cellular Plan.

• Or go to Settings → Cellular → Add eSIM → Use QR Code.

• Follow the on-screen steps to finish installing the eSIM.

Step 4 — Restore defaults

After the eSIM is added successfully, put the phone back to normal:

1. Settings → General → VPN & Device Management → profile «Turbosimproxy eSIM» → Remove Profile.

2. Settings → Wi‑Fi → (i) → Configure Proxy → Off.

Common issues

• No internet after setting the proxy: re-check Server and Port, and that you are still on that Wi‑Fi network.

• eSIM verification failed: confirm Certificate Trust was enabled in Step 1.

• Asked for proxy password: enter username khach and password esim@2026 again — no leading/trailing spaces.

Need help? Contact Turbosimproxy support on WhatsApp from the site contact menu.